Clean the surface to be polished.

how to use 3m perfect-it rubbing compound

As an Amazon Associate, I earn from qualifying purchases.

The 3M Perfect-It Rubbing Compound is essential to achieve a flawless finish on your car. This post will guide you through the step-by-step measures of using this product to clear away scratches and swirl marks, leaving your vehicle looking brand new. Whether you are an efficient detailer or a DIY enthusiast, this guide will help you complete professional-level results.

Clean the surface to be polished.

Clean the surface to be polished.

Before using the 3M Perfect-It Rubbing Compound, thoroughly clean the surface you’ll be working on. Ensure you eliminate any dirt, dust, or unnecessary residue that could be present on the surface. Doing this will guarantee that the rubbing compound functions effectively and delivers optimal results. Use good car wash soap and water to clean the surface, and ensure it is scorched before applying the rubbing compound. Getting rid of any grime, dust, or excess stuff is critical to getting that sleek and perfect outcome when using the 3M Perfect-It Rubbing Compound.

Apply the rubbing compound to a foam or wool pad.

Apply the rubbing compound to a foam or wool pad.

For optimal results. Make sure to go for a top-notch pad for polishing and buffing to get the best results.  The type of pad you use will depend on the level of correction needed for the surface. A wool pad may be more suitable for heavier scratches and swirl marks, while a foam pad can be used for lighter defects.

Buff the surface until the desired level of shine is perfect.

Once you’ve applied the rubbing compound, buff the surface using the appropriate pad until the desired level of shine is achieved. Buff the surface using a round motion, applying even pressure until the proper level of shine is achieved. This process may take some time and patience, but the result will be a glossy and flawless finish. Remember to take your time and be patient; achieving the perfect shine takes careful attention to detail.

Clean off any excess compound with a clean microfiber cloth.

This is important because leaving excess compound on the surface can produce a dull or streaky finish. After you’ve buffed the surface, use a clean microfiber to wipe off any remaining compound. Mildly wipe the surface in a circular motion to be sure all excess compound is removed. This will ensure that the surface is debris-free and help bring out the true shine of the polished area. Also, a microfiber cloth will help prevent scratching or marring the surface. Taking time and carefully removing excess compounds is essential for a smooth and flawless finish.

Conclusion

In conclusion, the 3M Perfect-It Rubbing Compound can help you achieve a professional, high-quality finish on your car, boat, or other surface. Following the instructions carefully and taking time, you can effectively remove scratches and swirl marks to restore your car’s shine and luster. Test on a small area before going all out on the entire surface to ensure everything turns out just right. You can achieve impressive results with 3M Perfect-It Rubbing Compound with proper technique and attention to detail.

 

 

As an Amazon Associate, I earn from qualifying purchases.

2 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *